Skip to main content
Home Forums Performa 575 PRAM battery connector (and question) Performa 575 PRAM battery connector (and question)
Thread

Performa 575 PRAM battery connector (and question)

Performa 575 PRAM battery connector (and question) Hardware 8 posts Jul 26, 2015 — Jul 26, 2015
Hi folks....

Can someone point me to a link to buy the correct PRAM battery connector for a Performa 575?  I am looking for the connector that connects the PRAM battery to the logic board.  Or, if you happen to have one for sale (with wires or wires and a dead battery) that would be cool.

One more question....

Can someone tell me the mAh rating of the original PRAM battery?  I would like to build or buy a PRAM battery that is rated at a higher mAh rating than the original.

Thanks in advance!

jack

The Ray-o-vac 840 I removed was 800mAh at 4.5v. It had three rectangular 1.5v alkaline cells in it. 3 alkaline AAA batteries in a holder would make a suitable replacement- I would be inclined to place/install this outside of the computer as forgotten alkaline cells just love to leak.

The Rayovac 840 uses a 3p2c (3-Positions, 2-Contacts) pin header connector, with the leads connected on the two outermost contacts. It could also be described as a 4-position connector, but there's plastic filled into one of the holes so not really.

This should work for you:

https://www.futurlec.com/Connectors/HDCONNS4.shtml

http://www.ebay.com/itm/25x-Dupont-Wire-Jumper-Pin-Header-Connector-Housing-1x4-Male-Female-/131221943350

Just be careful with the polarity. Also, be sure to get the crimps that go into it as well: http://www.ebay.com/itm/141446678863

http://www.alibaba.com/product-detail/4-5v-LR50-button-cell-battery_1893536659.html?spm=a2700.7724857.35.1.0B7SVq

4_5v_LR50_button_cell_battery_pack.jpg_220x220.jpg.7a8e5eb991444efe6eb9a677fb83e30c.jpg


Thanks every one.  I will dig in and select something.

jack

mp.ls