Hi,
no, the photos aren't from my logic board, and I didn't post them. I believe they've been taken from another thread where there was a question about how to insert the roms correctly, hence the single misplaced ROM.
I double-checked the position of the ROMs in the sockets and double-checked the bad ROMs in a known-good Performa 200. No luck, the ROMs are toast. I didn't try to find out which one exactly is dead, as I figured I'd like to replace them both to get the same timing etc., to avoid other problems.
Is there any place on the MoBo I could continuity-check the ROM sockets against to get a pinout of the ROMS?
Where are the hardcore, low-level hardware guys in this forum? I need you badly ;-) .
Thanx a lot,
MacGyver
no, the photos aren't from my logic board, and I didn't post them. I believe they've been taken from another thread where there was a question about how to insert the roms correctly, hence the single misplaced ROM.
I double-checked the position of the ROMs in the sockets and double-checked the bad ROMs in a known-good Performa 200. No luck, the ROMs are toast. I didn't try to find out which one exactly is dead, as I figured I'd like to replace them both to get the same timing etc., to avoid other problems.
Is there any place on the MoBo I could continuity-check the ROM sockets against to get a pinout of the ROMS?
Where are the hardcore, low-level hardware guys in this forum? I need you badly ;-) .
Thanx a lot,
MacGyver