C4 1uF 50v -> 1uF 35v
C5 1uF 50v -> 1uF 35v
C15 1uF 50v -> 1uF 35v
C24 1uF 50v -> 1uF 35v
Sorry for the disinformation - these were supposed to say 1uF (they were replaced with ones, just a copy paste typo) - they are lower voltages than the 50, that is still an issue and what I was trying to draw attention to ...I checked that twice before I posted it and still got it wrong.
Normally I re-tin the pads and the caps, prior to soldering them and I have had pretty good luck with the se/30's (and some Tandy's that I did previously), but the IICX I last did had traces that were bad from the corrosion and this one has something that is not quite right. Might try sending it off to Uniserver (to have a look or re-re-recap?) in a week or two if I can't hash it out.
C5 1uF 50v -> 1uF 35v
C15 1uF 50v -> 1uF 35v
C24 1uF 50v -> 1uF 35v
Sorry for the disinformation - these were supposed to say 1uF (they were replaced with ones, just a copy paste typo) - they are lower voltages than the 50, that is still an issue and what I was trying to draw attention to ...I checked that twice before I posted it and still got it wrong.
Normally I re-tin the pads and the caps, prior to soldering them and I have had pretty good luck with the se/30's (and some Tandy's that I did previously), but the IICX I last did had traces that were bad from the corrosion and this one has something that is not quite right. Might try sending it off to Uniserver (to have a look or re-re-recap?) in a week or two if I can't hash it out.