Macintosh Plus - Horizontal Line

what did the Dead Mac Scrolls say about this?

Dead Mac Scrolls? What is it?

<techknight> http://lmgtfy.com/?q=Dead+Mac+Scrolls</techknight>

sorry, I am just a pain in the ass.

Of course I have googled that! I am unable to buy because I live in Turkey and it will take lots of money and ages to arrive. Anyways I think it's because of P1. Where the heck is P1 I just can't find P1

http://maccaps.com/MacCaps/Repair_books.html

1 - change all the caps

2 - C1 Should be changed with something heavy duty like this http://www.mouser.com/ProductDetail/Panasonic/ECW-FD2W395K/?qs=sGAEpiMZZMv1cc3ydrPrF5m%252btQWx%252bSdKfqDEEG59TPQ%3d

3 - Desolder all the pins of J4 and J2,  Clean/scrub any joints that were burnt/cracked with solder wick and flux and liberally re-solder all the pins  

4 - test it.

5 - if you still get that line then it could be this : Q4

Turkey is 220V, 50 Hz mains power, so the AB might be different than what we're used to?

Good call, but in this situation, no difference.

There goes my analog board. Still looks so clean

http://u.cubeupload.com/Fitzgerald/94bimage.jpeg

well it looks like according to the silkscreen on the unversal International version there.

J2 / J4 are the same

C1 is CR4

Q4 is Q3

i like how it say's (danger lethal voltages) instead of high voltages

Repairsman did it. Ed motherboard works but Plus motherboard gives the same horizontal error. Any help?