Replacement bezel now in place. Ive included a couple of photos of the screws that need to be removed to take the bezel off as well. Whilst it seems straightforward, be prepared for these screws to give you some headaches...



Top CRT/bezel screws... The bezel screw is in line with the ounded notch in the plastic, the CRT one is the big washered one at the top. Sorry about the crap iPhone 3gs camera...



And here's the bottom screws... Again, apologies for the bad picture...



And now it's time to put the case plastics back on then take it for a test drive to see if it powers up and boot into OF to suss out the firmware revision before I put a drive in it.