BTW, I am about to clean my 2 SE/30 boards. I plan to use a warm solution of Alconox detergent solution. I cleaned my Iici board with it then rinsed it in warm deionized water and it got all of the leaky CAP scum off of it. It got the board so clean that it literally sparkled but it did help to reveal that there was a little bit of crust left around the solder pads on a few of the chips. I was then able to scrape it off without damaging the pads or solder joints using the splintered end of a wooden shaft cotton swab (Q-tip) that was purposely broken.

My old thread on the Iici board cleaning and recap.

viewtopic.php?f=8&t=12189

The broken wooden Q-tip trick I learned from watching a painter clean out stuck paint residue in the nooks and crannies in HVLP spray guns.

Brian