Ok, I tried load.
From this thread I grabbed this image of pinouts.
viewtopic.php?f=8&t=19611&hilit=iicx+power+supply
With two separate hard drive, I tried it power it from pin 1 for +. I then tried pins 6,7,8. At 6&7 the relay clicking got rather fast. At pin 8 for ground, the relay held but there was a very quiet clicking (bot to relay). The fan would not even try to spin. The drive would try to spin, but not much and it would cycle like the fan did.
With the drive hooked up I did read the 5v supplies. They fluctuated between 2.1 and 3.8 volts.
So not sure if the supply is fine but needs a proper load or if its messed up and need some more parts tossed at it.
From this thread I grabbed this image of pinouts.
viewtopic.php?f=8&t=19611&hilit=iicx+power+supply
With two separate hard drive, I tried it power it from pin 1 for +. I then tried pins 6,7,8. At 6&7 the relay clicking got rather fast. At pin 8 for ground, the relay held but there was a very quiet clicking (bot to relay). The fan would not even try to spin. The drive would try to spin, but not much and it would cycle like the fan did.
With the drive hooked up I did read the 5v supplies. They fluctuated between 2.1 and 3.8 volts.
So not sure if the supply is fine but needs a proper load or if its messed up and need some more parts tossed at it.