Kona SD Manual 1

AJA Video: Kona SD Hardware Install 1 The minimum system requirements for your new Kona SD is an Apple Macintosh G4 2 The first step is to unplug the power from the back of your Macintosh. It's not 3 Connect a static wrist strap to your wrist, and the computer chassis. When you handle Dual Processor 800 Mhz, 512 MB Ram, and mandatory to unplug the power cord, the Kona SD, try not to touch the gold at least two Cheetah 10K RPM hard disks for however, it might be the only way you plated edge connector or the components. uncompressed video storage. know the power is really turned off! Your Kona SD features advanced electronics Final Cut Pro on Mac OS X requires the dual If your Mac is still asleep, and not powered that can be damaged by static discharges, processor Mac to operate effectively. Under down, you can cause damage to your Kona so a static wrist strap will eliminate this Mac OS X, performance is significantly SD and your Mac. danger. enhanced on dual processor system. 4 Remove a spare metal shield from the rear of the Mac back panel, and install the Kona 5 Now is also a good time to install the SCSI card for your disk array. You will need at 6 Remove the static wrist strap, and close your Mac. Now you can reconnect the SD into a free slot. least a Ultra 160 SCSI card from either power cord to the Mac. ATTO™ or Adaptec™ for real time The Kona SD should insert easily, and the uncompressed video. See the section on In later sections we will explain how to top of the shield will align so you can disk arrays for more information. connect the video, audio and VTR remote easily replace the screw to hold the card in cab…