Lisa 2 Upgrade Kit

Lisa 2 Upgrade Kit Customer Instructions Installation and Data Transfer 029-OS05-A Lisa 2 Ungrade Kit Customer Instructions The following procedures describe the process of loading the Lisa 2 software on a Lisa 1 that has been upgraded to a Lisa 2. Before continuing, be sure you have completed the items on the following checklist. Have you: 1) Received your update to the Workshop? Language product (Workshop, Pascal, Basic, COBOL) versions that ran with orfice System 1.0 will NOT be compatible with this new release of the Office System. Those who have purchased the language products should order an update to them before installing this upgrade. 2) Loaded your documents to the ProFile? You should have loaded the documents you wish to save on ProFile before bringing your system to the dealer for installation of the retrofit hardware. If you are performing the retrofit yourself) the procedure for saving your documents is described in appendix 1 at the end of this docurrent. This process takes anywhere from ten minutes to tVJlO hours, depending on the arrount of data you wish to save. 3) Had the upgrade hardware installed? The dealer typically performs this part of the upgrade. If you have received this kit without access to a dealer t you can perform the upgrade following the procedures in appendix 2 at the end of this document. This process takes about one-half hour. 4) Purchased enough micro diskettes to contain the documents you wish to save? The procedure requires that the user purchase enough microdiskettes to carry all of the customer's data files saved on the ProFile. This would be a maximum of eight for each ProFile; two are included with the kit. Once you have completed these steps, continue with the software installation instructions on the following page. 029-0S0S-A Page 1·· Appendix 2: Lisa Z Hardware Installation The upgrade kit consists of five hardware parts) plus software: 1) micro diskette drive carrier assembly 2) Lisa 2 front panel 3) 28-pin CPU board boot ROM - high (part #341-0175) 4) 28-pin CPU board boot ROM - low (part #341-0176) 5) 24-pin I/O ROM (part 1341-0290) Software: 4 Office System micro diskettes, LisaGuide, and Applications micro diskettes Detailed descriptions of the Lisa 2 hardware upgrade procedure are given in the service procedures binder update for Lisa 2. Those procedures should be used to perform the upgrade. The process is also described below, referencing section H, "Service)" of the original Owners Guide that carne with the Lisa. The only tools required are a screwdriver for rerroval of socketed PROMs, and small wire cutters. Diagrams to supplement the Owners Guide material are given at the end of this document. 1) Remove the disk drive assembly by following the instructions on page Hi through H5 of the Lisa Owner's Guide. 2) See figure 1 at the end of this document. The disk drive cables coming from the Lisa are already fastened to the fioor or the drive compartment one on top of the oth…