Skip to main content
Home Forums 68kMLA Radius PrecisionColor/19 — #6
Post #6 by equill
Source Forum68kMLA
CategorySoftware
Post DateThu, 9 Jul 2009 - 20:49
Original URLhttps://68kmla.org/bb/threads/radius-precisioncolor-19.17906/
Post
Try starting from cold (ie, not a warm reboot). Press and hold in the 'T' key for as long as it takes the card to strut its stuff and cycle through the available configurations. Each will appear for about 4sec, giving you a rectangle with a more-or-less readable message

Release the T key when this message is properly displayed and the defined corners are at the edges of the display ...
Timing: 640 x 480 @ 67Hz
that changes the 'Timing: ' line with each available. When your Nirvana arrives, release the 'T' key. The Mac should restart and use the configuration that was in use immediately before release of the key. All of this assumes that the Installer on the RadiusWare diskette has previously been used to install the software of its choice for your Mac.

A 24XP will give you 832 x 624 (max.) at 24-bit. If the display is a PrecisionColor 19, there will be no WYSIWYG mode and no two-page mode such as the 8XJ and 24X cards offer.

de

mp.ls