Switch SW1
 
        Key 1   OFF(*)   Reserved
 
Select SCSI ID
        Keys    2       3       4       SCSI ID
                OFF*    OFF*    OFF*    0
                OFF     OFF     ON      1
                OFF     ON      OFF     2
                OFF     ON      ON      3
                ON      OFF     OFF     4
                ON      OFF     ON      5
                ON      ON      OFF     6
                ON      ON      ON      7
 
Switch SW2
 
SCSI bus parity
       Key 1    ON(*)   Enabled
                OFF     Disabled
Synchronous Data Transfer Request Mode (SDTR)
       Key 2    OFF(*)  Disabled from TARG
                ON      Enabled from TARG
Device mode
       Key 3    OFF(*)  Direct access device (INQ = 00)
                ON      Optical memory device (INQ = 07)
Automatic spindle stop mode
       Key 4    OFF     Disabled
                ON(*)   Enabled
Command compatibility
       Key 5    OFF(*)  Sony MO compatible
                ON      ANSI compatible
       Key 6    OFF(*)  RESERVED
Macintosh Mode
       Key 7    OFF(*)  Mac mode off
                ON      Mac mode on
Send/Receive Diagnostic Command
       Key 8    OFF(*)  Rejected
                ON      Accepted
 
Terminal CNH 1   (For drives with serial above 30,000)
 
SCSI Terminating Power
     1-2        3-4        Function
     SHORT(*)   SHORT(*)   Power is supplied from the drive to both
                           the terminating resistor pack and the TERMPWR
                           pin on the SCSI bus. (Pin 26)
     OPEN       SHORT      The TERMPWR pin is not used. Power is supplied
                           to the drive terminating resistor only from
                           the drive.
     SHORT      OPEN       Power is not supplied to the terminating resistor
                           from the drive, only from the TERMPWR pin.
 
Terminal CNH1   (For drives with serial below 30,000)
 
SCSI Terminating Power
     1 - 2      SHORT(*)   The TERMPWR pin is not used. Power is supplied
                           to the drive terminating resistor only from
                           the drive.
     2 - 3      SHORT      Power is not supplied to the terminating resistor
                           from the drive, only from the TERMPWR pin. (Pin 26)
 
Terminal CNH1   (For drives with serial above 30,000)
 
 
     Pin        Signal
      1         CTRGIN (Cartridge in)
      2         -ID2 (bit value 4)
      3         +5VS
      4         -ID1 (bit value 2)
      5         ELED (LED control)
      6         -ID0 (bit value 1)
      7         EJSW (Eject switch)
      8         Ground
      9         DEVMD (Device mode)
      10        No connection
      11        MACMD (MAC Mode)
      12        No connection
 
Terminal CNH2   (For drives with serial below 30,000)
 
 
      Pin       Signal
       1        -ID2 (bit value 4)
       2        -ID1 (bit value 2)
       3        -ID0 (bit value 1)
       4        Ground