Thanks for going the extra mile for me in setting up that wonderful testing kluge, I really like it! Also thanks for posting your well documented results of the, first ever, Radius Color Pivot II/IIsi in an SE/30 test.
The fit shouldn't be an issue, I'll send you the modified riser card I hacked from the SuperMac IIsi RA PDS adapter along with the Serial Cable I forgot to pack for your 2300cTB. [
] ]'>
I'm not even close to being discouraged about this combo yet!
Possible problems:
First: make sure there were are a pair of jumpers on that particular card. I swiped one for another test off one and that was probably the one.
From the pics, it looks like they're properly in place for one of the two available PseudoSlot Addresses, we can still try the other.
I'll check the Se/30's memory mapping to see if it's set to a IIsi only Slot ID and if the other Slot ID is recognized
You didn't happen to run SlotInfo from the Gauge series did you?
I forgot all about it and I wasn't thinking straight about using just the Monitors Control Panel for testing in the SE/30. There could be several software/driver issues contributing to the Monitors Control Panel being insufficient as a test tool. My bad! I think I'll copy these docs to the RCPII/IIsi thread for continuity there.
The fit shouldn't be an issue, I'll send you the modified riser card I hacked from the SuperMac IIsi RA PDS adapter along with the Serial Cable I forgot to pack for your 2300cTB. [
] ]'>I'm not even close to being discouraged about this combo yet!
Possible problems:
First: make sure there were are a pair of jumpers on that particular card. I swiped one for another test off one and that was probably the one.
From the pics, it looks like they're properly in place for one of the two available PseudoSlot Addresses, we can still try the other.
I'll check the Se/30's memory mapping to see if it's set to a IIsi only Slot ID and if the other Slot ID is recognized
You didn't happen to run SlotInfo from the Gauge series did you?
I forgot all about it and I wasn't thinking straight about using just the Monitors Control Panel for testing in the SE/30. There could be several software/driver issues contributing to the Monitors Control Panel being insufficient as a test tool. My bad! I think I'll copy these docs to the RCPII/IIsi thread for continuity there.