I was at the doctor's office today for an upper endoscopy, so I got the day off cuz of the anesthesia.
Here's what I worked on, I'm gonna attempt to print it when I get to work tomorrow, see how it fits. It's a case for BMOW's FloppyEmu.
The two square holes in the front are for LEDs. I'm gonna solder a red and green to the status and power LEDs on the board so they'll blink up front. I'm also making buttons that'll fit in the holes on top. Unfortunately I don't think my 3D printer is fine enough detail to put embossed lettering on the case, so I think I'll use water decals.
I added the grooves and rounded corners typical of vintage Macs.
Kinda looks like a Lisa from a certain angle... Ooo. Maybe I could make a miniature Lisa case that sits vertically. :lol:
Here's what I worked on, I'm gonna attempt to print it when I get to work tomorrow, see how it fits. It's a case for BMOW's FloppyEmu.
The two square holes in the front are for LEDs. I'm gonna solder a red and green to the status and power LEDs on the board so they'll blink up front. I'm also making buttons that'll fit in the holes on top. Unfortunately I don't think my 3D printer is fine enough detail to put embossed lettering on the case, so I think I'll use water decals.
I added the grooves and rounded corners typical of vintage Macs.
Kinda looks like a Lisa from a certain angle... Ooo. Maybe I could make a miniature Lisa case that sits vertically. :lol: