Color Page Suite Manual

User's Manual for the Microtek Color PageWiz Personal Scanner (for Macintosh) © 1997 MICROTEK LAB, INC. All rights reserved. Trademarks Microtek and PageWiz are trademarks of Microtek International, Inc. Other product or company names are trademarks or registered trademarks of their respective holders. Important Documents you scan may be protected under copyright law. The unauthorized use of such documents could be a violation of the rights of the copyright holder. Microtek bears no responsibility for the unauthorized use of copyrighted materials. Doc. No. I49-001465 First Edition December 1996 Microtek Lab, Inc. Microtek International, Inc. 3715 Doolittle Drive No. 6, Industry East Road 3 Redondo Beach, CA 90278 Science-based Industrial Park U.S.A. Hsinchu, Taiwan 30077 Tel: 310-297-5000 R.O.C. Fax: 310-297-5050 Tel: 886-3-5772155 BBS: 310-297-5102 Fax: 886-3-5772598 AutoTech Fax Back: 310-297-5101 Technical Support: 310-297-5052 Microtek Europe B.V. Adara International, Inc. Max Euwelaan 68 9th Fl., No. 2 NL - 3062 MA Rotterdam Min Sheng E. Road, Sec. 3 The Netherlands Taipei, Taiwan Tel: 31-10-242-5688 R.O.C. Fax: 31-10-242-5699 Tel: 886-2-501-6699 Fax: 886-2-504-0137 Federal Communications Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient/relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Note: A shielded interface cable with ferrite core installed on the scanner connector end must be used with this equipment. Caution Changes or modifications not expressly approved by the manufac- turer responsible for compliance could vo…