PCM README

Miramar Systems, Inc. PC MACLAN version 6.01 ----------------------------------------------------------------------------- This document may contain information not found in the manual. Please read. ----------------------------------------------------------------------------- CONTENTS I. Installing II. Upgrading from Personal MACLAN v5.5x or PC MACLAN v6.0(1) III. Unlisted Adapters Information (ODI & NDIS3) IV. Errors during Installation V. Errors during operation VI. Incompatible Network Adapters VII. Performance Issues VIII. Uninstalling ============================================================================= I. Installing to Windows 95 A.Run Install from DISK1 1.Standard Installation assumes that you are installing the AppleTalk stack to connect to an Ethernet or Token-Ring network. 2.To install Personal MACLAN Connect onto a LocalTalk network, select Custom Installation and check the Network Transport option. This will give you the opportunity to add an ODI adapter. 3.After installing Personal MACLAN Connect, the AppleTalk protocol stack needs to be entered into the Windows 95 registry. The installer will do this for you. Do not reboot your system until after this has been accomplished. B.If the protocol and client get removed from the Network Control Panel applet follow the steps listed below to setup the AppleTalk protocol and client for Ethernet or Token-ring networks: 1.Select the CONTROL PANEL from your computer 2.Select the Network ICON 3.Select the ADD button 4.Select Adapter (if there is one previously installed skip to #9) 5.From the manufacturer list choose your ethernet card's maker 6.From the list of adapters select the adapter you installed 7.Select OK 8.If you do not wish to connect to other PCs, remove the two Microsoft clients and the IPX/SPX protocol and the NETBEUI protocol 9.Select Add 10.Select Protocol 11.Select ADD 12.Under Manufacturers List box choose Miramar Systems, Inc. 13.Select the Miramar Systems AppleTalk v6.0 using NDIS3 protocol and press OK 14.Select the ADD button 15.Select Client 16.Select ADD 17.Under Manufacturers List box choose Miramar Systems, Inc. 18.Select OK 19.Select OK again to enter the new values into the Windows registry 20.Select YES to Restart WINDOWS 95 C.To setup the ODI LocalTalk AppleTalk protocol and client do the following: 1.Select the CONTROL PANEL from your computer 2.Select the Network ICON 3.Select the ADD button 4.Select Adapter (if there is one previously installed skip to 9) 5.From the manufacturer list choose "(installed localtalk driver)" 6.From the Network Adapters list select "Existing ODI LocalTalk Driver" 7.Select OK 8.Select Add 9.Select Protocol 10.Select ADD 11.…